.PYC File Format – Line numbers

How to read it

Start with the address at 0 and the line at co_firstlineno. For each pair, the address step is an unsigned byte and the line step is a signed byte: a value of 0x80 or more means that value minus 256. The instructions from the current address up to, but not including, the new address belong to the current line. Then add both steps.

addr = 0
line = co_firstlineno
for addr_step, line_step in pairs:
    if line_step >= 0x80:
        line_step -= 0x100
    addr += addr_step
    if addr > target:
        return line
    line += line_step
return line

The last line reached applies to every instruction after the final pair. A negative step is possible because a later instruction can belong to an earlier line.

Large steps

A step too large for one byte is spread over several pairs. An address step over 255 uses extra pairs of 255, 0 first. A line step above 127 or below −128 uses pairs with an address step of 0 after the first.

A worked example

This example is constructed by hand from the rule above; it was not compiled by CPython 3.7. Take a module of three lines:

a = 1
b = 2
print(a + b)

Its instructions are, by the encoding on the instructions page, two bytes each. co_firstlineno is 1 and co_lnotab is 04 01 04 01:

Offsets from 8 onwards are line 3. A signed step works the same way: in a table of 06 01 04 FF, the pair 04 FF adds 4 to the address and −1 to the line, moving back to the previous line.